Goodyear 1070675 Technical Specifications
| Specification | Details |
|---|---|
| Manufacturer | Goodyear Belts |
| Part Number | 1070675 |
| Belt Type | Multi-V Serpentine |
| Rib Count | 7 |
| Nominal Length | 67.5 inches |
| Metric Length | Approximately 1,715 mm |
| Alternate Number | 7PK1715 |
| Rubber Material | EPDM |
| Cord Material | Balanced-twist polyester |
| Primary Application | Engine accessory drive |
| Replacement Category | Automotive aftermarket |
Why Replace Your Serpentine Belt?
Your vehicle’s serpentine belt transfers rotational power from the engine crankshaft to important accessories.
Depending on the vehicle, these may include the alternator, water pump, power steering pump, and air conditioning compressor.
A worn serpentine belt can cause:
-
Squealing or chirping during engine startup
-
Visible rib wear, fraying, or missing belt material
-
Alternator charging problems
-
Reduced hydraulic power steering assistance
-
Engine overheating when the water pump is belt-driven
-
Air conditioning compressor problems
-
Excessive belt vibration
-
Unexpected accessory drive failure
For additional automotive maintenance information, explore the repair and troubleshooting guides at My Pro Street Online.
EPDM Rubber and Polyester Cord Construction
The Goodyear 1070675 combines EPDM rubber with balanced-twist polyester tensile cords.
EPDM is commonly used in modern serpentine belts because of its resistance to engine compartment heat, ozone exposure, and environmental aging.
Polyester cords help maintain belt length and provide strength under operating loads.
Together, these materials support reliable accessory drive performance across changing engine speeds and temperatures.
Unlike older belt materials, EPDM belts may wear significantly without developing obvious surface cracks. Checking rib wear and pulley condition is therefore an important part of routine maintenance.
When Should You Replace Your Serpentine Belt?
The supplied product information references Auto Care Association guidance recommending belt inspection around 60,000 miles and replacement around 90,000 miles.
These figures are general maintenance guidelines rather than universal requirements.
Actual replacement intervals depend on vehicle manufacturer recommendations, belt condition, operating environment, and accessory drive wear.
If your belt is producing unusual noises or showing signs of deterioration, inspect the tensioner and pulleys before replacing it.
Goodyear 1070675 vs. Standard Replacement Belts
The Goodyear 1070675 features a seven-rib Multi-V design intended for compatible accessory drive systems.
Its EPDM construction and polyester tensile reinforcement help support long-term durability, consistent power transfer, and smooth operation.
However, matching belt length and rib count does not automatically guarantee vehicle compatibility.
Pulley routing, accessory configurations, and engine-specific belt requirements must also match.
Installation and Maintenance Recommendations
Before installing the Goodyear 1070675, inspect the entire accessory drive system.
Check the belt tensioner, idler pulleys, alternator pulley, and other driven accessories for wear, noise, or misalignment.
Follow the manufacturer’s belt routing diagram and verify that all seven ribs are seated correctly.
Avoid using sharp tools to force the belt over pulleys, as this can damage the internal reinforcement.
Proper installation helps maximize belt service life and reduce premature accessory drive problems.
Buy Goodyear 1070675 Serpentine Belt at Pro Street Online
Maintain reliable engine accessory operation with the Goodyear Belts 1070675 7-Rib, 67.5-Inch Serpentine Belt.
Featuring reinforced EPDM construction and balanced-twist polyester cords, this replacement belt is designed for select Acura, Honda, Chevrolet, GMC, and Peterbilt applications.
Shop replacement serpentine belts, alternator drive belts, and automotive maintenance components at Pro Street Online.
There are no reviews yet.