Engine and Trim Verification
The standard Corolla, Matrix and Vibe generally use Toyota’s 1.8L 1ZZ-FE engine. Performance variants may use the higher-output 2ZZ-GE, including certain:
- Toyota Matrix XRS models
- Pontiac Vibe GT models
- Toyota Corolla XRS models
Do not assume this starter fits XRS or GT applications without matching the original starter number. Both engines say “1.8L,” which is useful right up until the mounting pattern disagrees.
Specifications
| Specification | Detail |
|---|---|
| Voltage | 12 volts |
| Power rating | 0.6 kW |
| Rotation | Counterclockwise |
| Pinion teeth | 9 |
| Starter design | PMGR |
| Condition | New |
| Package quantity | One starter |
PMGR stands for permanent-magnet gear-reduction. This design uses internal gear reduction to provide useful cranking torque from a relatively compact starter assembly.
Replacement Numbers
This starter is advertised as a replacement for:
- 17841
- 336-1768
- SND0295
- ND280-0330
- 280-0330
- 428000-0340
- 428000-0341
- 428000-1311
- 9642809-034
- 88969483
- SR107298
- 28100-0D080
- 28100-22090
- 2-2360-ND
At least one number should match the original starter or a trusted VIN-based catalog before ordering.
Check Before Replacing the Starter
A no-crank condition can also be caused by:
- Weak or discharged battery
- Loose battery terminals
- Corroded positive cable
- Poor engine ground
- Faulty starter relay
- Park/Neutral position switch problem
- Clutch-interlock switch failure
- Damaged ignition-switch circuit
- Seized engine
Measure battery voltage and perform voltage-drop testing before condemning the starter. Replacing a starter because the battery terminal is dirty is technically a repair—it’s merely a very expensive version of cleaning.
Installation Notes
Before installation:
- Disconnect the negative battery cable.
- Compare both starters before removing protective packaging.
- Verify the mounting flange and electrical terminals.
- Confirm the nine-tooth drive gear.
- Clean the starter mounting surface.
- Position the starter squarely against the engine or transmission.
- Start all mounting bolts by hand.
- Tighten the fasteners evenly to factory specifications.
- Confirm the positive cable cannot contact ground.
- Reconnect the battery and test operation.
Never pry against the installed starter to change its position. If it does not sit flush, stop and determine why.
Final Verdict
This 17841 starter is intended for select 2003–2008 Corolla, Matrix and Vibe 1.8L models. The key restrictions are the Corolla’s assembly location and the exact engine configuration.
Confirm the VIN, engine code and OE number before purchase—especially for Corolla XRS, Matrix XRS and Pontiac Vibe GT models.
There are no reviews yet.